Rolling pin with Handle – Cobblestone Small


2 in stock

SKU: 8436574509823ES Category:


Textured Roller with Handle

Textured Rolling Pins with handle capable of pressing a continuous repeated pattern on all kinds of sculpting putties, polymer clays, and pastes.

Made of clear PMMA plastic with amazing non-stick properties.

Their small size and the innovative design of their ergonomic handle make them an easy tool to transport and use.

There are different textures available that make them compatible with different modeling scales. The textures are scalable to cover large surface areas. Also, its handle allows us to print textures creating curves to give more realism to the model or base.

Roller Width: 4 cm (1.5 inches)

Roller Length with Handle: 14cm (5.5 inches)

Diameter: 2’5cm (1 inch)

Scale: 28-32mm (1/64-1/48)

* The textured rolling pins and their handles are presented unassembled. In the following link there is a photo guide to help its assembly.


1st – Properly mix the putty/clay until ready according to the manufacturer’s recommendations.

2nd – Extend the putty/clay on a surface to be textured. For optimal results, make sure you have got a smooth and even surface before impressing with the Rolling Pins. *** We recommend using a plain Rolling Pin for this.

3rd – Depending on the type of putty/clay, it is advisable to wet the Rolling Pin to prevent any sticking.

4th – Slowly move the Rolling Pin applying equal pressure at all points for an even texture.

5th – Trim any excess putty/clay with a sharp knife. It is recommended to do this once it has dried to avoid any deformations in the putty/clay.




There are no reviews yet.

Be the first to review “Rolling pin with Handle – Cobblestone Small”

Your email address will not be published.